Reloop Spin!2+ Mode D'emploi page 152

8. SPIN! 2+ INTERFACE SPÉCIFICATIONS
1. GENERAL SECTION
MODEL: .................................................................... SPINU2A
POWER SOURCE: ................................................... USB5V, 500mA
DIMENSION: ............................................................ 180(W) x 137(D) x100.2(H) mm
WEIGHT: ................................................................... 0.78 kg
2. FEATURES:
• 4 Channel analog input/output with through output.
• High level master output.
• Phono/Line selector with gain adjust.
• Midi control panel.
• Earphone output with direct switch, split adjust and gain adjust.
• Input/output signal indicate by LED.
• Microphone input with active voltage supply, gain adjust and throughout.
• USB V1.1 Connect Computer RECORD&PLAY.
3. INPUT/THROUGH OUT SECTION: ................... (LINE IN: -14dBV, LOAD= ? OHM)
CH. BALANCE: ........................................................ Within 0.5 dB
LEVEL DIFFERENCE: ............................................ Within 0.5 dB
4. PLAYBACK SECTION: ........................................ (Microphone switch off, Windows playing speaker
FREQUENCY RESPONSE: ...................................... (Phones out= 0 dBV output; TCD781 Track 1, 4(for
LINE: ......................................................................... 17-20K Hz ±2 dB
PHONES: .................................................................. 61-20K Hz ±3 dB
THD + N: .................................................................. (Phones out = 0dBV OUTPUT, A-Weighted, W/20KHz
PHONES: .................................................................. Less than 0.1%
MAXIMUM OUTPUT: .............................................. (TCD781 Track 1)
LINE: ......................................................................... THD<=0.02%,More than +6 dBV (2.0V)
PHONES: .................................................................. THD<=1%,More than +1.6 dBV (1.2V)
OUTPUT NOISE: ..................................................... (W/20KHz LPF, A-Weighted,
PHONES: .................................................................. Less than -70 dBV(Adjust Gain Maximum)
S/N RATIO: .............................................................. (W/20KHz LPF,
LINE: ......................................................................... More than 85 dB
PHONES: .................................................................. More than 75 dB
CH. SEPARATION: .................................................. (W/20KHz LPF, A-Weighted; TCD781 Track 32,38)
LINE: ......................................................................... More than 85 dB at 1K Hz between L and R.
PHONES: .................................................................. More than 65 dB at 1K Hz between L and R.
CH. BALANCE: ........................................................ (Phones out = 0dBV; TCD781 Track 1)
LINE: ......................................................................... Within 1 dB
PHONES: .................................................................. Within 1 dB
FADER MAXIMUM ATTENUATION: ...................... (1K Hz Line in= -14 dBV and Phones out = 0 dBV,
144
maximum, Phones load= 33 ohm, Line out load=
47K OHM)
line), 6(for phones), 18)
LPF; TCD781 Track 1)
at load = 47K OHM
at load = 33 OHM
playback TCD781 track 1 then pause)
Phones out=0dBV,A-WEIGHTED; TCD781 Track 1)
More than 85 dB at 1K Hz between channels.
A-Weighted W/20K Hz LPF; TCD781 Track 1)