Publicité
Les langues disponibles
Les langues disponibles
-
BATTERY CHARGER CARD (41629/052)
This optional accessory allows connecting the
batteries to the control unit controlling their optimal charge and
increasing their duration.
During battery operation the beacon ON time is reduced and the warning
light signalling the unclosed status changes from ON to shortly ON.
-
BATTERY CHARGER CABLE (41629/051)
This optional accessory allows connecting the batteries to the control unit.
During battery operation the beacon ON time is reduced and the warning
light signalling the unclosed status changes from ON to shortly ON.
-
AUXILIARY OUTPUT CARD (code MCH2 41626/050)
N.C. = normally closed contact
N.O. = normally open contact
Any error or fault signals are issued simultaneously through the red LED DL10, the warning light output and the
beacon output:
-
3 flashes = saving failed
-
4 flashes = safety device test failed
-
5 flashes = faulty motor or encoder
LBT0499 – DS41627-001 – FW 1.01 - 2020
Optional cards and accessories
This optional card allows having
an output with dry changeover contact, controlled
via remote control. Insert it with control unit off in the
CN2 connector, as shown in the figure
on the left side.
It complies with the
not timed and non-settable stepper function.
Meaning of acronyms
Error or fault signal
BATTERY CHARGER
Publicité
