Publicité
Accessories
Please check you received the following accessories with your Fisher & Paykel washer.
You will find them inside the drum or attached to the packaging.
2 x Inlet hoses
●
1 x Drain hose guide
●
1 x Installation instructions and User guide
●
1 x Wrench
●
1 x Installation leaflet (attached to the top of the washer)
●
Unpacking
WARNING!
Recycle or destroy the carton and plastic bags after the washer is unpacked. Make
materials inaccessible to children. Children might use them for play. Cartons covered with
rugs, bedspreads or plastic sheets can become airtight chambers causing suffocation.
To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging:
Remove the outer packaging. Note: a small amount of water may be seen inside the
1
packaging and inside the washer. This is the result of factory testing and is normal.
Tilt the machine backwards and 'walk' it off the base one foot at a time. Not doing so
2
may cause damage to your floor and washer.
Remove all packaging and accessories from inside the drum. Note: DO NOT remove the
3
screw or clip holding the hose.
Removing the transit bolts
The clothes washer is fitted with 4 transit bolts at the rear to avoid damage during
transportation.
IMPORTANT!
The 4 transit bolts MUST be removed prior to operation of the machine. Failure to
remove these will result in damage to the machine.
8
INSTALLATION INSTRUCTIONS
Publicité
