Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SERVICE INSTRUCTIONS

CHANGE BLADES

4
8
5
10
C190-0142
1
Turn the chipper off and remove the ignition keys.
2
Remove battery leads.
3
Remove the 3 nuts retaining the rotor housing blade access hatch,
slide hatch clear of rotor housing.
4
Turn rotor to blade change position.
5
Insert locking bar into rotor housing and rotor.
3
6
Brush away all dirt and debris from the rotor and blades.
7
With a 24mm spanner/socket undo the two nyloc nuts and washers
that are holding the blade in place.
8
Remove blade bolts while holding blade in position. The inner bolt on
the inner blade passes through the hole in the roller box. If necessary
tap the bolts to loosen.
9
Grasp the blade by the flat edges while wearing heavy duty gloves.
10
Withdraw the blade from the rotor.
11
Rotate blade to use 2nd edge or replace with a new or sharpened
blade.
12
Clean the back surface of the blade, blade bolts and blade area of the
rotor before reseating blades. The blades must not have any material
underneath them when tightened. If they are not flat and tight they
will become loose very quickly.
13
Reassemble the blades, bolts, washers and nuts in the order shown
in the diagram. Use only genuine Timberwolf nuts and washers, as
they are of a higher grade than normally stocked at fastener factories.
Failure to use the appropriate grade nuts or washers may result in
damage, injury or death. The use of genuine Timberwolf blades and
bolts is recommended.
14
Apply a smear of anti seize compound (copper ease) to the bolt
threads and back face of the nuts. Do not apply copper grease onto
the counter bore faces of the blades or bolts.
15
A calibrated torque wrench must be used to tighten the bolts to a
torque setting of 125lb ft (170Nm).
16
Remove lock pin, rotate rotor to next blade then replace lock pin and
repeat steps 6 - 14.
17
Refit rotor housing blade access hatch.
18
Refit the nuts and tighten to 40 lbs ft (54 Nm).
19
Refit battery leads.
19 / 65
01.03.2019
TW 280TDHB/(a)
WEAR MARK
Rev: 2.0

Publicité

Chapitres

Table des Matières
loading

Table des Matières