Service Instructions; Service Schedule - Timberwolf TW 280TDHB Manuel Opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SERVICE INSTRUCTIONS

SERVICE SCHEDULE

SERVICE SCHEDULE
Check coolant.
Check radiator is clear.
Check hydraulic oil level
Check engine oil - top up if necessary (10W-30).
Check for engine oil / hydraulic oil leaks.
Check fuel level.
Check feed funnel, feed roller cover, access covers,
engine covers and discharge unit are securely fitted.
Check blades.
Clean air filter element.
Check tyre pressure is 3.4 Bar (50 psi).
Check safety bar mechanism.
Check for tightness all nuts, bolts and fastenings
making sure nothing has worked loose.
Grease discharge flange.
Check tension of main drive belts (and tension if
necessary).
Grease the roller box slides.
Grease the roller spline and bearing.
Check anvils for wear.
Check fuel pipes and clamp bands.
Check battery electrolyte level.
Check for loose electrical wiring.
Replace hydraulic oil filter - every year or 100 hours
after service or repair work to the hydraulic system.
Replace hydraulic oil.
Replace fuel pipes and clamp bands.
Check coolant condition.
Change engine oil.
Replace engine oil filter cartridge.
Check valve clearance.
Replace anvils when worn.
Axle maintenance.
Tow head maintenance.
To assess the wear condition of the braking system, and troubleshoot any problems relating to the braking system or axle,
please refer to the 'Brake Operation Handbook' and 'AL-KO document 580458' as supplied.
C190-0142
15 / 65
Daily
50
Check
Hours
ü
ü
ü
ü
ü
ü
ü
ü
DEPENDING ON WORKING ENVIRONMENT
ü
ü
ü
ü
ü
ü
OR AS REQUIRED - SEE PAGE 21
ü
OR AS REQUIRED - SEE PAGE 21
ü
REFER TO YOUR ENGINE SUPPLIERS MANUAL
RETURN TO DEALER FOR ANVIL CHANGE
REFER TO SUPPLIERS INSTRUCTION SHEET
01.03.2019
TW 280TDHB/(a)
100
500
Hours
Hours
ü
ü
ü
ü
OR
ü
OR
1
Year
ü
ü
Rev: 2.0

Publicité

Chapitres

Table des Matières
loading

Table des Matières