Transportation And Handling; Before Operation - Hitachi YUTAKI M Serie Manuel D'utilisation

TRANSPORTATION AND HANDLING

3 TRANSPORTATION AND HANDLING
When hanging the unit, ensure a balance of the unit, check
safety and lift it up smoothly
Do not remove any packing materials.
Hang the unit under packing condition with two ropes.
For safety reasons ensure that the outdoor unit is lifted smoothly
and does not lean
Gross
Model
Weight (kg)
RASM-3VNE
115
RASM-4VNE
135
RASM-5VNE
140
RASM-6VNE
144

4 BEFORE OPERATION

!
C A U T I O N
• Supply electrical power to the system for approximately 12 hours
before start-up or a long shut-off. Do not start the system immediately
after power supply, it may cause a compressor failure because the
compressor is not heated well.
• When the system is started after a shut-off longer that approximately
3 months, it is recommended to check the system by your service
contractor.
4.1 FACTORY-SUPPLIED UNIT COMPONENTS
Accessory Image
Gasket
CD-ROM
Instruction
manual
Declaration of
-
conformity
3 PMML0342B rev.1 - 03/2016
Gross
Model
Weight (kg)
RASM-4NE 140
RASM-5NE 145
RASM-6NE 149
Qty. Purpose
Two gaskets for each space
2 heating connections
(inlet/outlet)
With the detailed Installation
1
and operation manual
Basic instructions for the
1
installation of the device.
1 -
RASM-3VNE
• Turn OFF the main switch when the system is to be stopped for a long
period of time: If the main switch is not turned OFF, electricity will be
used, because the oil heater is always energised during compressor
stopping.
• Make sure that the outdoor unit is not covered with snow or ice. If
covered, remove it by using hot water (approximately 50°C). If the
water temperature is higher that 50 °C, it will cause damage to plastic
parts.
?
N O T E
• The previous accessories are supplied inside the unit.
• If some of these accessories are not packed with the unit or any
damage to the unit is detected, please contact your dealer.
RASM-(4-6)(V)NE
> 60º
0.7 -1.0 m