Zummo Nature Z40 Adapt Manuel D'utilisation page 33

Assembly
After washing and drying the components, assemble them in the following order:
Screw the balls into the squeezer tray. Make sure you have fitted the washers first and
1
TIGHTEN the balls well! Then, adjust the position of the balls as you can see in the picture,
the slots must coincide with the mark of the tray (Fig. 18).
Insert the blade in the squeezer tray and slot the ribs into the grooves of the balls
2
(Fig. 19). Check that the blade slides easily.
Square up the squeezer tray set and blade to their respective shafts (Fig. 20) and then
3
insert the cups in the squeezer tray and square them up to the shafts (Fig. 21). Assemble
this set in the machine at the same time and tighten the nuts well.
Fit the shafts and the pulp scraper filter in the filter, fit the filter correctly in its position in
4
the filter tray, Self-service tray or tank (THE DRIVE SHAFT SHOULD OVERHANG THE
TRAY OR TANK) (Fig. 22) and fit the set into the machine. Check that the tray or tank is
fitted properly which will also indicate that the filter is in the right position (THE DRIVE
SHAFT SHOULD DOVETAIL WITH THE HEXAGONAL FILTER ACTUATOR) (Fig. 23).
Affix one of the side panels back on the machine (Fig. 13).
5
Assemble the cover by attaching it to the side panel (Fig. 14).
6
Finally, affix the last side panel.
7
Before operating the machine, make sure that:
•
Juice tray and blade are properly fitted in place.
•
Fastening nuts are properly tightened.
•
The correct set of squeezing parts (balls, cups and fruit selector) are fitted. (see
"Accessories" in this manual).
•
Ensure that the side panels are properly coupled with the locking system for the
machine to operate properly.
If blade, juice tray, balls, cups, side cover or front cover are not correctly assembled, serious
damage may be caused to these parts or to the interior components of the machine.
Cleaning the feeder
•
Undo the basket's retaining nut (Fig. 24).
•
Remove the external basket by turning it gently.
•
Unscrew the nut located inside the basket (Fig. 25).
•
Remove the hopper fruit classifier pulling it upwards (Fig. 26).
•
Remove the basket together with the lower fruit classifier by pulling upwards until it is
completely released from its shaft (Fig. 27a-27b).
•
Clean all the pieces with soapy water or put them in the dishwasher.
•
Reassemble in this order: first fit the basket together with the lower fruit classifier onto the
shaft (fit the lower fruit classifier in the position of the calibre of oranges you intend to
squeeze, either for the medium kit (Fig. 4) or the large kit (Fig. 5); for the extra large kit it
should be removed (Fig. 6) and then turn the basket manually until it is anchored (the pivots
should enter their respective holes). Then affix the fruit classifier inside the basket, making
sure it fits properly and cannot turn (Fig. 26), screw in the nut and finally fit the external basket
(Fig. 24).
Important Notice:
The normal use of the machine may cause the plastic parts that are exposed to juice to turn of
the fruit colour. This is completely normal and does not imply a hygiene problem or affect the
physical properties of the plastic.
33
(Operator faults not covered by the guarantee)