Repairs; Environmental Protection; Troubleshooting; Technical Specifications - Metabo KS 216 M Lasercut Notice Originale

en ENGLISH

13. Repairs

Danger!
Repair of power tools must be carried out by
qualified electricians only!
If you have Metabo power tools that require
repairs, please contact your Metabo service
centre. For addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

14. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of
disused machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive 2002/
96/EC on waste electrical and electronic
equipment and its implementation in national
legal systems, used power tools must be
collected separately and handed in for
environmentally compatible recycling.

15. Troubleshooting

Following you will find a description of problems
and faults that you may remedy yourself. If the
corrective measures described here do not help,
kindly refer to chapter 13. "Repairs".
Danger!
There are particularly many accidents in
connection with problems and faults. Therefore
keep in mind:
 Prior to each correction of faults, pull the mains
plug or remove the detachable battery pack
(27).
 Check that all safety devices are operational
again after each fault service.
No trimming function
Transport lock activated:
 pull out transport lock.
Safety lock activated:
 loosen safety lock.
Cutting power too low
Saw blade blunt (possibly tempering marks on
blade body);
Saw blade unsuitable for the material (see
chapter 12. "Accessories");
Saw blade contorted:
 Replace saw blade (see chapter 10.
"Maintenance").
Saw vibrates a lot
Saw blade contorted:
 Replace saw blade (see chapter 10.
"Maintenance").
Saw blade not installed properly:
 Install saw blade properly (see chapter 10.
"Maintenance").
Turntable hard to turn
Chips under turntable:
 remove chips.

16. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U = mains voltage / voltage of battery pack
I = rated power
F = min. fuse protection
P = rated input power
1
IP = protection class
n = no-load speed
0
v = max. cutting speed
0
D = saw blade diameter (outer)
d = saw blade hole (inside)
b = max. tooth width of the saw blade
A = dimensions (lxwxh)
m = weight
16
Requirements for chip and dust extraction unit:
D = connection diameter of the extraction
1
nozzle
D = minimum air throughput
2
D = minimum negative pressure at extraction
3
nozzle
D = minimum air speed at extraction nozzle
4
Maximum cross-section of workpiece, see table
on page 4.
~
AC Power
Direct current
Machine in protection class II
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or
lower. For assessment purposes, please allow for
breaks and periods when the load is lower. Based
on the adjusted estimates, arrange protective
measures for the user e.g. organisational
measures.
Typical A-effective perceived sound levels:
L = sound-pressure level
pA
L = acoustic power level
WA
K , K = uncertainty
pA WA
Wear ear protectors!