Additional Functions; Control Of Equipment Via App - Ferroli 200 LT-S Manuel D'utilisation, Installation Et Entretien

6.6 Additional functions

6.6.1 Anti-Legionella
The display shows the symbol
Every two weeks, at the set time, a water heating cycle is car-
ried out by means of the heating element inside the tank, up to
the anti-legionella temperature, maintaining it for the set time.
If, on reaching the anti-legionella temperature, the cycle is not
performed correctly within 10 hours, it is stopped and will be run
again after 2 weeks.
If the request for the anti-legionella function occurs with HOLI-
DAY mode selected, the anti-legionella cycle will be carried out
immediately when the unit is reactivated after the set days of
absence.
Anti-legionella parameters
Anti-legionella temperature set-point (P3)
Anti-legionella cycle duration (P4)
Anti-legionella cycle activation time (P29)
6.6.2 Defrost function
The display shows the symbol
This equipment has an automatic evaporator defrost function
which is activated, when the operating conditions require it, dur-
ing heat pump operation.
Defrosting occurs through the injection of hot gas into the evap-
orator, allowing it to be rapidly defrosted.
During defrosting, the heating element, which the equipment is
provided with, is switched off unless otherwise set via the in-
staller menu (parameter P6).
The max. duration of defrosting is 8 minutes.
6.6.2.1 Frost protection
The display shows the symbol
This protection prevents the water temperature inside the tank
from reaching values close to zero.
With the equipment in standby mode, when the water tempera-
ture inside the tank is below or equal to 5°C (parameter configu-
rable via installer menu), the frost protection function activates,
which switches on the heating element until 12°C is reached
(parameter configurable via installer menu).
90
EN
EGEA
.
Range Default
50÷75°C 75°C
0÷90 min 30 min
0÷23 h 23 h
.
.
cod. 3541T600 - Rev. 04 - 05/2020
200 LT-S - 260 LT-S - 200 LT - 260 LT

6.7 Control of equipment via APP

This water heater has a Wi-Fi module integrated in the product,
enabling connection to an external Wi-Fi router (not supplied)
and therefore being controlled via smartphone APP.
Depending on the availability of a smartphone with Android
iOS operating system, via the dedicated app.
®
Download and install the "EGEA Smart" app
Start the "EGEA Smart" app from your smartphone by pressing
the icon as indicated above.
User registration
To use the "EGEA Smart" application for the first time, user
registration is required: create a new account → enter the mo-
bile number/email address → enter the verification code and set
the password → confirm.
Press the register button to register, then enter your mobile
number or email address to obtain the verification code needed
for registration.
fig. 28
or
®