Onkyo HT-RC160 Manuel D'instructions page 216

Getting to know Your Speaker Package—Continued
Attaching the Speaker Bases
Before you connect the speakers, attach the supplied
speaker base to each SKF-770.
1. Turn the speaker upside down with the protection
cover attached.
2. Align the speaker base while the arrow mark
headed in the same direction as the speaker's face.
Be careful not to tip over the speaker.
3. Align the screw holes on the speaker base with
those on the bottom of each speaker, and affix the
speaker base using the supplied screws.
Recommended torque is 10 kgf·cm (9 lbf·in).
Be careful not to tip over the speaker.
4. Turn the speaker right side up.
5. Remove the protection cover.
SAFETY PRECAUTIONS:
• Attach the speaker bases in a manner that will not
allow the speakers to tip over.
• Be sure to tighten the screws when you attach the
speaker bases.
• Attach the speaker bases on a flat, level, and stable
floor.
• After you attach the speaker bases, make sure that the
speakers stand upright and are stable.
8
En-
Top of SKF-770
is
Protection cover
Supplied screws
Arrow mark
Speaker base
Bottom of SKF-770