JVC KW-XR811 Manuel D'instructions page 29

Category Menu item
Ring Color *
3,
Fad/Bal *
Fader/balance
Loud
Loudness
Volume
Adjust
Subwoofer
HPF
High Pass
Filter
2
* Displayed only when USB Bluetooth adapter, KS-UBT1 is connected.
3
* If you are using a two-speaker system, set the fader level to <0>.
4
* This adjustment will not affect the subwoofer output.
Selectable setting, [
2
• On : When a call comes in, the display will flash in blue.
• The display will change to the original color when
When the unit receives a SMS, the display only
illuminate in blue.
• Off : Cancels.
: Fad (fader): Press 5 / ∞ to adjust the front and rear
4
* R6 – F6, [ 0 ]
speaker output balance.
: Bal (balance): Press 4
L6 – R6, [ 0 ]
left and right speaker output balance.
• Loud 1/2/3 : Boost low and high frequencies to produce a well-
balanced sound at a low volume level.
• Off : Cancels.
Level –5 — : Preset the volume adjustment level of each source
Level +5, (except FM), compared to the FM volume level. The
[ Level 0 ] volume level will automatically increase or decrease
when you change the source.
• Before making an adjustment, select the source you
• "FIX" appears on the display if "FM" is selected as the
• LPF : Turn the control dial to select the cutoff frequency
• Level : Turn the control dial to adjust the subwoofer
• Phase : Turn the control dial to select the subwoofer phase.
Select the cutoff frequency to the front/rear speakers. Set this to
match the LPF settings.
• 62Hz/95Hz/ : Frequencies lower than 62 Hz/95 Hz/135 Hz are cut
135Hz
• Off : All signals are sent to the front/rear speakers.
Initial: Underlined
the call is answered or the incoming call stops.
want to adjust.
source.
to the subwoofer.
Off: All signals are sent to the subwoofer.
LPF 55Hz/LPF 85Hz/LPF 120Hz: Frequencies
higher than 55 Hz/85 Hz/120 Hz are cut off.
output level. Level 00 to Level 08 [ Level 04 ]
0deg (normal) or 180deg (reverse)
off.
]
/ ¢
to adjust the
ENGLISH 29