INSTALLING THE (OPTIONAL) ANTENNA
Screw the antenna into the connector
on the top of the transceiver by
holding the antenna at its base and
turning it clockwise until secure.
INSTALLING THE BELT CLIP
If necessary, attach the belt clip using
the two supplied M3 x 8 mm binding
screws.
Note:
If the belt clip is not installed, its
●
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
CAUTION
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver.
Acrylic ester, which is contained in these glues, may crack the
transceiver's back panel.
Optional
antenna
Belt clip
M3 x 8 mm
screws
15