Operation; Manual Operation; Continuous Operation - MC Crypt X-1200 Notice D'emploi

6. Commissioning
c) Operation
Always pull the mains plug before filling the fog machine.
Never fill the machine with flammable liquids or add these to the fog liquid. Only ever use a
suitable water-based fog liquid (the CONRAD range features suitable fog liquid, see "Technical
Data").
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device, cause
damage there or injure the operator.
Make sure that no liquid enters the internal workings of the device when you are filling it with
fog liquid. This can lead to damage to the device and can cause deadly electrical shocks.
• Make sure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill liquid into the tank.
• Screw the tank cover firmly back into place.
• Plug the connection plug of the remote control into the port WIRE CONTROLLER on the back of the fog machine.
• Insert the mains plug into an earthed mains socket.
• Switch on the device with the POWER mains switch. When the device is switched on, the mains switch is lit and
the fog machine heats up.
• The warm-up process takes about 4 minutes.
• Once the device has reached its operating temperature, the green indicator LED on the remote control is list and
the device is ready for operation.

Manual operation:

• Press the green button MANUAL on the remote control.
• The device emits fog as long as you keep this button depressed.

Continuous operation:

• Press the red button CONT on the remote control.
• The device emits fog permanently and the red indicator LED is lit.
• Set the desired fog quantity with the VOLUME control.
• To deactivate permanent operation, press the red button CON'T on the remote control again.
23