Commissioning; Setup - MC Crypt X-1200 Notice D'emploi

6. Commissioning

Carefully read the complete operating manual and the safety instructions before using the
product in order to ensure proper commissioning.
Check the device for damage before using it for the first time. If the device is damaged, do not
operate it and consult an expert or our service team.
a) Setup
Installing the device may only be carried out by qualified personnel who are familiar with the
hazards involved and the relevant regulations. Repairs, operation and maintenance of the
product may only be carried out by qualified personnel.
When choosing a location for your device, make sure to avoid vibration, dust, hot and cold
temperatures and dampness. Furthermore, no powerful transformers or motors must be set up
in the vicinity of the device.
When setting up the device, make sure that the connection cable is not crushed and cannot be
damaged by any sharp edges.
Do not use the device on flammable surfaces or in the proximity of flammable objects. Maintain
a distance of at least 0.5m to flammable objects.
Make sure that the fog output opening is not directed towards persons, animals or open fires.
The emerging hot steam may lead to burns (keep a safety distance of 0.5 m)!
Ensure a sufficient ventilation of the device; maintain a free zone of 0.2m around the device and
never cover the ventilation openings.
Always place the appliance on a stable base. Ensure that it does not fall down and causes injury.
The device's operating position is horizontal (max. tilt: 15°) so that the tank does not leak when
filling and operating the device.
The device must be mounted out of normal reach. If the fog machine is set up in an elevated
location, make sure no one can enter the space beneath it (danger of slipping and injury through
hot fog liquid and its residues).
During installation and service work, the area underneath the place of installation must be
cordoned off.
The area or equipment of installation must be designed in such a way that it can support the
tenfold rated load for at least one hour without being deformed permanently.
All statutory regulations applicable in the respective country must be observed when setting
up the device.
21