Pioneer ELITE BDP-88FD Mode D'emploi page 60

09
Problem
The audio files stored on
components on the network,
such as a computer, cannot
be played back.
The audio files stored on
components on the network,
such as a computer, cannot
be played back.
Playback does not start.
The computer is not properly
operated.
Cannot access Windows
Media Player 11 or Windows
Media Player 12.
Video and audio playback are
undesirably stopped or
disturbed.
60
En
Check
The audio component on the
network which has been
switched off is switched on.
Audio files recorded in
MPEG-4 or AAC are being
played back on Windows
Media Player 11 or Windows
Media Player 12.
The folder stored on the
omponent connected to the
network has been deleted or
damaged.
The component is currently
disconnected from this unit
or the power supply.
The corresponding IP
address is not properly set.
You are currently logged onto
the domain through your
computer with Windows 7
installed.
The LAN cable is currently
disconnected.
There is heavy traffic on the
network with the Internet
being accessed on the same
network.
Remedy
There are cases where a component with Internet security software
installed cannot be accessed.
Switch on the audio component on the network before switching on
this unit.
If the client is automatically authorized, you need to enter the
corresponding information again. Check whether the connection
status is set to "Do not authorize".
Check the audio files stored on the component connected to the
network.
Install Windows Media Player 11 or Windows Media Player 12 on your
computer.
Play back audio files recorded in MP3, WAV (LPCM only), MPEG-4 AAC,
or WMA. Note that some audio files recorded in these formats may not
be played back on this unit.
Audio files recorded in MPEG-4 AAC cannot be played back on
Windows Media Player 11 or Windows Media Player 12. Try using
another server. Refer to the operation manual supplied with your
server.
Check whether the component is affected by special circumstances or
is in the sleep mode. Try rebooting the component if necessary.
Try changing the settings for the component connected to the network.
Check the folder stored on the component connected to the network.
Check the computer's network settings, security settings, etc.
Check whether the component is properly connected to this unit or the
power supply.
Switch on the built-in DHCP server function of your router, or set up the
network manually according to your network environment.
The automatic configuration process takes time. Please wait.
Instead of logging onto the domain, log onto the local machine.
Check whether the audio file was recorded in a format supported by
this unit.
Even audio files listed as playable on this unit may sometimes not be
played back or displayed.
Check whether the folder has been damaged or corrupted.
Connect the LAN cable properly.
Use 100BASE-TX to access the components on the network.