Getting Started; Making Settings Using The Setup Navigator Menu - Pioneer ELITE BDP-88FD Mode D'emploi

Chapter 3
03

Getting Started

Making settings using
the Setup Navigator
menu
Be sure to perform these settings when using the player
in the following situations.
• When you use the player for the first time.
• After Initial Setup format.
Caution
• Before turning on the power, check that the
connections between the player and other devices are
correct. Also, turn on the power of the devices
connected to the player before turning on the player's
power.
• When using a Pioneer TV or front projector
compatible with the Control function, set Control to
On on the connected device before turning on the
player's power.
TOP MENU
TOP
HOME MENU
1 Turn on the TV's power and switch the input.
See the TV's operating instructions for the details of
operating the TV.
2 Turn on the player's power.
Press  STANDBY/ON.
Check that the Setup Navigator menu is displayed.
24
En
POPUP MENU
POP
UP
ENTER
RETURN
 If the Setup Navigator menu is not
displayed
 Press
HOME MENU to display the Home
Menu, select Initial Setup  Setup Navigator 
Start, then press ENTER.
3 Start Setup Navigator.
Press ENTER.
• Setup Navigator starts.
4 Select the OSD language.
Use / to select, then press ENTER.
5 Select the appropriate output resolution for the
connected TV.
Use / to select, then press ENTER.
6 Select the appropriate aspect ratio for the
connected TV.
Use / to select, then press ENTER.
7 Close the Setup Navigator menu.
Press ENTER.
• Setup Navigator finishes and the setting is stored.
• Press RETURN to go back to the previous
screen.