Toshiba RBC-TWP30E2 Manuel D'installation page 15

INDOOR UNIT OPERATION WHEN CONNECTED TO MULTIPLE UNITS
When you want to know position of the indoor unit using the address
To confirm the unit numbers in a group control
(Operation while the air conditioner stops)
The indoor unit numbers in a group control are successively displayed, and the corresponding indoor fan is turned
on.
Procedure
VENT
Push
1
• UNIT No.
• The fans of all the indoor units in a group control are turned on.
Every pushing
group control are successively displayed.
2
• The firstly displayed unit numbers indicates the address of the main
unit.
• Only fan of the selected indoor unit is turned on.
TEST
3
Push button to finish the procedure.
All the indoor units in group control stop.
To confirm all the unit numbers from an arbitrary wired remote controller
(Operation while the air conditioner stops)
The indoor unit numbers and position in the same refrigerant cycle line can be confirmed.
An outdoor unit is selected, the indoor unit numbers in the same refrigerant cycle line are successively displayed,
and then its indoor unit fan is turned on.
Procedure
Push the timer time
4 seconds or more.
1
Firstly, the line 1, item code
(Select outdoor unit.)
UNIT LOUVER
2
Using
SET
Using
3
• The indoor unit address, which is connected to the refrigerant cycle
line of the selected outdoor unit is displayed and the fan is turned
on and all display of indoor unit turned on.
Every pushing
4
same refrigerant line are successively displayed.
• Only fan of the selected indoor unit operates.
To select another line address
5
CL
Push button to return to procedure
• The indoor address of another line can be successively confirmed.
TEST
6
Push button to finish the procedure.
TEST
+ buttons simultaneously for 4 seconds or more.
is displayed.
UNIT LOUVER
button, the indoor unit numbers in the
TEST
+ buttons simultaneously for
(Address Change) is displayed.
SWING/FIX
+ buttons, select the line address.
button, determine the selected line address.
UNIT LOUVER
button, the indoor unit numbers in the
Description
Description
2
.
– 15 –
CODE No.
SET DATA
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
1, 3 2
CODE No.
SET DATA
UNIT No.
R.C. No.
TEMP. ON / OFF
TIMER SET FAN MODE
1
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
1, 6
3
5 2
1
2, 4