8005 And 9005 Electronic Control Operation; Initial Start-Up; Auxiliary Controls - Cal Spas Home Resort Fitness Serie Guide D'utilisation

8005 and 9005 Electronic Control Operation

When first powered up, the electronic system will
perform a self-diagnostic check and then it will
automatically heat to and maintain a temperature of
37.5˚C until you change the set temperature as listed
in the "Temperature Adjustment" section below.
These instructions will describe features and options
that your particular spa may not be equipped with.

Initial Start-up

When your spa is first powered up, it displays some
configuration codes and then goes into priming mode
(Pr will appear on the display panel). This mode lasts
up to four minutes and then the spa begins to heat to
its pre -programmed temperature of 37.5˚C. You can
exit the priming mode early by pressing UP or DOWN
buttons.
Temperature Adjustment (26.0˚C -
40.0˚C)
The start-up temperature is set at 37.5˚C. The last
measured temperature is constantly displayed on
the control panel. Note that the last measured spa
temperature is displayed. The displayed temperature
will be updated when the pump has been running for
at least two minutes.
Press the UP or DOWN buttons once to display the
set temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the control panel will automatically display
the last measured spa temperature.
2012 Portable Spa
LTR20121001, Rev. A

Auxiliary controls

Time
When time hasn't been programmed, the TIME icon
flashes. To set the time, press the TIME button and
then the MODE/PROG button. Use the UP and DOWN
buttons to adjust time. See the next page for more
detailed instructions.
15
www.calspas.com