Napoleon Galaxy Serie Manuel D'installation Et D'opération page 33

WARNING
!
• The appliance area must be clear and free from combustible materials, gasoline, and other flammable vapours
and liquids. Do not obstruct the flow of combustion and ventilation air. Keep the ventilation opening of the
cylinder enclosure free and clear of debris.
To access the orifice:
1. Remove the glass shield, glass embers and screws securing the burner tray in place. Lift the tray and set it on
its side or supported on an angle. Take care not to damage pilot tube and wires.
1
2. Remove the flex hose and the orifice from the burner.
Reinstallation: Reverse the procedure to reinstall the burner tray. Check that the orifice enters the burner when
installing. Replace the glass embers and the front glass shield. When the appliance is put back in service, compare
the burner flame pattern to the images in the "Operation" section to verify that the appliance is operating correctly.
Cleaning the Outer Appliance Surface: Do not use abrasive cleaners or steel wool on any painted or stainless
steel parts of your Napoleon appliance. Doing so will scratch the finish. Exterior surfaces should be cleaned with
warm soapy water. To clean stainless surfaces, use a stainless steel or a non-abrasive cleaner. Always wipe in the
direction of the grain. Over time, stainless steel parts discolour when heated, usually to a golden or brown due. This
discoloration is normal and does not affect the performance of the appliance.
maintenance / cleaning instructions
EN
33
W415-3006 / A / 05.27.21