Top Panel - Arcam rCube Mode D'emploi

The Top Panel contains touch-sensitive buttons for
standby, selecting sources, and changing the volume. Each
button has an LED above it which illuminates to indicate
each button press.
Power and Standby
At the centre of the top-panel is the standby button.
When the rear-panel rocker switch is on, the 2 button
on the top-panel (or on the remote) toggles between fully
on (blue front LED, or purple when using battery power) and standby
mode (red LED).
Source Selection
You can switch between listening to the iPod dock or AUX rear
panel sources by pressing the SOURCE button (see table below). To
select a wireless source instead, press the WIRELESS button. This
will de-select any AUX or iPod source and start playing from
the optional USB or iPod Transmitter. When a wireless source is
selected, the wireless indicator will glow continuously.
Indicator LEDs
The top panel LEDs illuminate to indicate source selection and volume
adjustment. When using the remote control, the power LED flashes to
confirm reception of remote commands.
SOURCE
WIRELESS
STANDBY
VOLUME
DOWN
VOLUME
UP

Top Panel

Chooses local source to play: AUX-in
(red illumination) or iPod (green).
Chooses available wireless sources to
play: searching (red) or locked (green).
Turn rCube from standby (red LED)
to on (blue/purple) or place unit into
standby.
Reduces volume. Press and hold to
smoothly reduce the volume.
Increase volume. Press and hold to
smoothly increase volume.
E-9
In order to use the wireless transmitter
you must first set it up. See the section
"Setting up the rWave Optional USB
transmitter" on page E-18 or "Setting up the
rWand Optional iPod transmitter" on
page E-20
?
Changing the Volume and Muting
A short press of - or + will increase or
decrease the rCube's volume a small
?
amount or you can press and hold
the button to ramp the volume up or
down. Pressing both volume buttons
simultaneously will instantly mute all
sound coming from the device. Both
volume LEDs (- & +) are illuminated
when the rCube is muted. Press any
volume button to release the Mute
function.
>
>