Upgrading The Firmware - Arcam rCube Mode D'emploi

The rCube has the ability to have its software
upgraded by the user. This allows additional
features to be added and allows compatibility
with yet to be released iPods and iPhones.
You should only upgrade the
firmware if directed by Arcam or
your dealer
To upgrade the rCube you will need a USB flash
drive and a PC or laptop computer that can
connected to the internet.
1
Download the firmware file to your
memory stick.
Visit www.arcam.co.uk to download the
latest firmware and place the file on your
USB flash drive.
There must not be any other files present
on the drive.
2
With the rCube off, insert
the USB flash drive.
First make sure the rCube is
fully powered off (using the rear
panel switch) and then insert
the memory stick with the
downloaded file into the USB
style upgrade port on the rear
panel of the unit.

Upgrading the Firmware

3
Power on the rCube into standby mode
Turn the rCube on by pressing the power
rocker switch on the
rear panel. Press and
hold the standby
button until the power
LED flashes red. The
power LED will flash red rapidly while the unit is
upgrading. When the LED will stops flashing and
glows continuously, the rCube is updated.
4
Remove the memory stick
It is now safe to remove the memory stick.
O I
E-23
? >
? >
If the rCube is put into upgrade
mode accidentally, turn off the power.
When the power is turned back on,
the rCube will operate normally.
VOLUME
? >
SOURCE
Aux iPod
PROGRAMME
NAVIGATE