Playing From The Rwave - Arcam rCube Mode D'emploi

Playing from the rWave Optional USB Transmitter
The Arcam rWave wireless USB transmitter lets you play
music anywhere in the home from files on your PC.
NOTE: You will need to associate each cube with a wireless
transmitter before that cube can receive audio.
1
Install the rWave USB transmitter
into your PC or laptop.
Plug the USB disk drive-style rWave transmitter
into a free USB port in your computer. The
computer will recognize the device as a sound device.
You may need to enable audio output to the rWave ("Arcam
Wireless DAC") in your system settings — some operating
systems do this automatically. You can check to see if the rWave is
broadcasting by looking at its LED, which will flash briefly every five
seconds when transmitting.
2
Power up
Plug the power supply into the AC mains wall supply and the DC power
input jack on the rear panel of the rCube. Switch on the rCube by pressing
power switch on the rear panel, and press the top panel standby button.
The blue power LED should light.
3
Select the rWave as wireless source
To select the rWave transmitter, press the 'Wireless' button on the rCube
remote control or on the top panel. If a source is available the light will
turn green and the source will begin to play. Note: if a second wireless
source is also transmitting you may have to press the 'Wireless' button
twice to select the correct transmitter.
4
Play tunes on the computer
Go to iTunes or your favourite software music player and choose and play
a song. N.B. Always insert the USB transmitter before starting iTunes.
5
Adjust volume
Use the + and - volume buttons on the remote or on the top panel to
adjust the volume to desired level.

E-19
1
O I
2

