Adjust Volume; Playing From An Ipod Or Iphone - Arcam rCube Mode D'emploi

1
Power up
Plug one end of the laptop-style power supply
into the AC mains wall supply and the other
into the DC power input jack on the rear panel
of the rCube. Switch the rCube on by pressing
its power rocker switch on the rear panel. The
front LED will glow red (standby mode). Press
the standby button on the top panel or on the
remote. The power LED will change from red to
blue and the rCube is now on.
2
Dock the iPod
Open the dust cover to reveal the universal
docking well. Gently insert your iPod or iPhone
onto the connector.
When docking or removing, insert the
iPod gently and at the same angle as
the connector. Do not twist or pull the
iPod while it is in contact with the dock
connector! This can damage the connector.
3
Select iPod as the source
When the iPod is docked, the rCube will automatically select iPod
as the source and the source button will glow green. If the iPod is in
the dock but not the current source, press the source button on the
remote control or on the top panel until the source LED glows green.
4
Choose track and play
Use your iPod controls or rCube remote to select a track and begin
audio playback.
5

Adjust volume

Use the + and - volume buttons on the remote or on the top panel to
adjust the volume to desired level.
NOTE: The Apple iPad is too large for the docking connector, but can be
connected wirelessly using a transmitter accessory. See page E-20.

Playing from an iPod or iPhone

E-13
O I
1
2
ME NU
, .
;4



