Sony MDR-DS6000 Mode D'emploi page 27

Symptom Cause and remedy
The DOLBY PRO , The EFFECT switch on the processor is set to "OFF."
LOGIC II indicator
, Analogue input signal, digital input PCM signal, Dolby Digital 2-channel
does not turn on
The DOLBY PRO , The EFFECT switch on the processor is set to "CINEMA" or "MUSIC" mode.
LOGIC II indicator
, Analogue input signal, digital input PCM signal, Dolby Digital 2-channel
turns on
The DTS indicator , The DTS digital output setting on the DVD device (including game machines)
does not turn on
, Playback signals are not recorded in DTS format.
, The audio for the chapter being played is not a DTS signal.
, The DVD device does not support DTS format.
MPEG-2 AAC , Playback signals are not recorded in MPEG-2 AAC format.
indicator does not
light up.
The battery , Check if the CHG indicator turns on. If not, put the headphones on the
cannot be
charged
, Dry batteries are installed.
, Rechargeable batteries other than the supplied are installed.
, The processor's contact pin and headphones' contact point are dusty.
The CHG indicator
, 3 and # of the rechargeable battery do not match those in the battery
blinks.
, The rechargeable battery is damaged.
RF signal
, Signal noise is output from the connected analogue component.
transmission does
not stop. (when the
INPUT SELECT
switch on the
processor is set
to "ANALOG")
signal or MPEG-2 AAC 2-channel signal is not input.
signal or MPEG-2 AAC 2-channel signal is input.
is set to "OFF."
• See the instruction manual of your DVD device, and change the DTS digital
output setting to "ON."
• Use a DVD device that supports DTS.
processor correctly so that the CHG indicator turns on.
• Insert the supplied rechargeable nickel-metal hydride battery.
• Insert the supplied rechargeable nickel-metal hydride battery.
• Wipe them with a cotton bud, etc.
compartment correctly.
• Insert the rechargeable battery with correct polarity.
• Replace it with a new one. The rechargeable battery, type BP-HP2000, is not
commercially available. You can order the battery from the store where you
purchased this system, or at your nearest Sony dealer.
• Unplug the connected analogue component, or set the INPUT SELECT
switch on the processor to "DIGITAL," and make sure playback of the
component connected to the DIGITAL IN jack is stopped.
Additional Information
(Continued)
GB
27