Sony MDR-DS6000 Mode D'emploi page 17

Setting the input level
If the volume is low using the analogue input, set the ATT (attenuator) switch to
"0 dB."
Setting
0 dB
–8 dB
Notes
• Be sure to lower the volume before setting the ATT switch.
• If audio input to the LINE IN jacks is distorted (sometimes, noise can be heard at the same
time), set the ATT switch to "–8 dB."
ATT
0dB -8dB
Connected components
TV, portable components, and other components with a low output level
Other components (initial settings)
17
Connection
GB