Listening To A Connected Component - Sony MDR-DS6000 Mode D'emploi

1 Operation

Listening to a Connected Component

Before starting, be sure to read "Connecting the
Headphone System" (pages 15 to 17) and make the proper
connections.
1
Turn on the component connected to the processor.
DVD device, digital satellite/TV
receiver, or other audio or video
component
2
Remove the headphones from the processor.
The processor turns on automatically and the RF indicator blinks for about 5
seconds. The processor automatically detects the optimum frequency for
transmission according to your room conditions. The RF indicator lights up when
emission from the processor starts. Then the DECODE MODE indicator lights up,
depending on the audio signal input from the connected audio or video
component and the setting of the EFFECT switch.
Signal transmission system
This unit employs a proprietary transmission system using 2.4 GHz frequency.
You can enjoy non-compressed sound with this wireless system.
3
Put on the headphones.
The POWER indicator lights blue, and the headphones automatically turn on.
Be sure to match the right and left side of the headphones with your ears and
wear the headphones at the correct angle so that the Auto Power On/Off function
works correctly. Sound is heard from the headphones about 3 seconds after you
put on the headphones.
GB
18
Operation
POWER
POWER
indicator