ensto ECO16BT Instructions D'installation Et De Fonctionnement page 26

External Temperature Control
5.10. You can use external temperature control, if external voltage is connected to the
thermostat.
Disable / Enable the function from "Settings / External control".
•
• From "Temperature" you can set the desired temperature value. The default temper-
ature setting for external control is 10 °C.
• "Temperature change" can be either a rise or a drop in the set point temperature.
• The blue LED indicator C is on when the external control is in use.
• If the external control is enabled you cannot use the adjustment knob for setting
temperature.
Home Screen, figure 9
F Active device
G Set point temperature
H Actual temperature
K On / Off button
L Enter editing mode
Resetting the Factory Settings
5.11. Reset the factory settings, figure 10:
• Remove the adjustment knob E.
• Press the Bluetooth button D on the thermostat.
• After 7 seconds, the blue LED indicator C starts to blink quickly.
• Paired devices, consumption information and calendar settings are removed. The
thermostat is in "Floor" mode.
6. Battery
6.1. The purpose of the battery is to maintain the time during power cuts. If the clock does
not keep correct time, the battery must be replaced. The battery change interval is several
years and is usage dependent.
The battery may only be replaced by a skilled or instructed person.
Disconnect the power supply before replacing the battery.
6.2. Replace the thermostat battery, figure 11.
• Remove the adjustment knob E and the cover.
• Replace the battery with the same type of battery as the original, CR1225.
• Put the cover and the adjustment knob E in place.
• Dispose of the empty battery according to local recycling guidelines.
26 / 84 RAK121 / 4.5.2021