ensto ECO16BT Instructions D'installation Et De Fonctionnement page 24

have paired the thermostat from the mobile device's own Bluetooth menu, the ap-
plication is not able to contact the thermostat. To correct the situation first remove
the thermostat from the mobile device's own Bluetooth menu and then pair it via the
application. When paired via application the connection works. The thermostat also
appears in the mobile device's own Bluetooth menu.
When pairing allow the Ensto Heat Control application to use the location service, if
the application requests it. It depends on the mobile device, if the application needs
permission to use the location service from the mobile device itself in order to use the
Bluetooth low energy radio on the mobile device. If you do not give the permission,
the application is not able to use the Bluetooth low energy radio and the application is
not able to connect to the thermostat. The Ensto Heat Control does not collect user's
location information and does not need the location service itself, but the application
requires the Bluetooth low energy radio for wireless data transfer between the appli-
cation and the thermostat.
5.2. Open the application. In the "DEMO" mode you can practice using the application. The
Tutorial video shows application's features and guides you through the commissioning. At
any time, you can go back to the Tutorial through the "Support" menu.
5.3. After the Tutorial, pair your mobile device with your thermostat (figure 8):
• Remove the adjustment knob E (1).
• Switch on the thermostat with the power switch A (2).
• Press the Bluetooth button D on the thermostat for 1 second (3). The blue LED indi-
cator C blinks (4).
• When the application has found your thermostat, your mobile device displays the
default name "New thermostat" .
Press the "New thermostat" button within 45 seconds (5).
•
• The blue LED indicator C turns off, when the pairing is completed or 45 seconds is
exceeded.
Now you can find your thermostat in "Devices / My devices".
•
• Put the adjustment knob E in place.
Operation Modes
Change the operation mode from the menu "Settings / Mode".
5.4.
• In "Floor" mode the thermostat adjusts the heating according to the floor tempera-
ture. Select the floor setting temperature with the adjustment knob E.
• In "Room" mode the thermostat adjusts the heating according to the room temper-
ature, in which case no floor sensor is needed. Select the room setting temperature
with the adjustment knob E. When measuring room temperature, the thermostat
adjusts to the prevailing conditions in a few hours, after which the precise operation
starts.
• In "Combination" mode the thermostat adjusts the heating according to the room
temperature as well as according to the minimum and maximum floor temperatures.
Define for the floor material appropiate minimum and maximum temperatures from
"Settings / Floor temperature limits".
If the floor temperature rises higher than the set temperature, the blue LED indicator
C blinks four times per minute as a warning and the load switches off until the floor
24 / 84 RAK121 / 4.5.2021