Replacing The Fuel Filter - WORMS P 52 EX Manuel D'utilisation

7. The paper element [(5) Fig. 35]: To clean the paper element, gently tap it a few times against
a hard surface to drop dirt, or blow with air compressed from the inside to out. Never brush
the element, the brushing would penetrate the impurities inside the fibers. Replace the paper
element when it is very dirty;
NOTE
Paper element is not washable.
8. Assemble the elements [(4) and (5) Fig. 37] and put them back in place;
9. Put back the wing nut [(3) Fig. 37];
10. Replace the cover [(2) Fig. 37] and correctly tighten the wing nut [(1) Fig. 37].
NOTE
Use only genuine parts.
9.4. SERVICING THE FUEL CUP
Every 100 hours of operation, remove water from the fuel filter:
1. Close the fuel valve [Fig. 31];
2. Remove the cup [(1) Fig. 38] and the O-ring [(2) Fig. 38], wash them in a non-flammable solvent.
Dry them completely and put them back in place;
3. Open the fuel valve [Fig. 18].

9.5. REPLACING THE FUEL FILTER

Replace the fuel filter, located at the bottom of the fuel tank, every 1000 operating hours.
NOTE
This operation should be performed by the dealer of by the nearest After Sales Service.
9.6. REPLACING THE FUEL PIPE
•
Replace the fuel pipes every 2 years or every 1000 operating hours. [Fig. 39]
•
In case a leak is detected on fuel pipes, replace them at once. Let the fuel flow into the container
and empty the tank
NOTE
This operation should be performed by the dealer of by the nearest After Sales Service.
44