Publicité
Les langues disponibles
Les langues disponibles
Paragraph 9 - Password
Programming
PROG
-
-
Password
****
Password
0000
-
Paragraph 10 – Flow Alarm
Programming
PROG
-
-
Alarms
Alarm Flow
Flow
Off
Off
Alarm Flow
On
-
Alarm Flow - On
Signals
Alarms
Flow
Paragraph 11 – Level Alarm
Programming
PROG
-
-
Alarms
Level
Stop
-
Paragraph 12 – Flow Display Unit
Programming
PROG
-
-
Unit
Standard
-
EM00136162
-
+
-
+
-
-
+
6
ESC
Off
-
Alarm Level
Stop
-
Alarm Flow
Alarm
ESC
Alarms
Level
Alarm
-
Unit
Standard
<-
-
+
Unit
L/h
-
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the
key to select the number (from 1 to 9), and the
key to select the number to be modified. Confirm by
pressing the
key. By setting "0000" (default), the
password is eliminated.
This makes it possible to activate (deactivate) the flow
sensor.
When activated (On), press the
request for the number of signals that the pump waits for
before an alarm is triggered. The number flashes when you
press the
key, and you can then use the
keys to set the value. Confirm by pressing the
Press
to return to the main menu
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
using the
keys to set the alarm type. Confirm by
pressing the
key. Press
main menu
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
using the
keys to set the unit of measurement,
choosing between L/h (litres/hour), Gph (Gallons/hour), ml/m
(millilitres/minute) or standard (% or frequency, depending
on settings). Press
main menu
rev 1.1
Operation
Operation
key to access the
Operation
to return to the
Operation
to confirm and return to the
key.
key, then
key, then
7
Publicité
