Athena AT PR Série Mode D'emploi page 8

Paragraph 6 – Power On Delay Setting
Programming
Paragraph 7 – Flow Calibration
Programming
PROG
-
-
Pump Calibration
0,23 cc/stroke
Pump Calibration
Manual
-
Pump Calibration
Automatic
-
Paragraph 8 - Statistics
Programming
PROG
-
-
Statistic
Hours 10
Statistic
Strokes 1000
-
Statistic
Q.ty(L) 100
-
Statistic
Power 10
-
Statistic
Reset
ESC
Statistic
Hours 10
-
EM00136162
-
Pump Calibration
+
cc/stroke 0,23
Automatic Cal.
Start 100 strok.
Automatic Cal.
Strokes 100
-
Automatic Cal.
+
ml 20
-
Statistic Reset
+
NO
Allows the user to set a pump activation delay time when turning on
the pump itself. This delay will only take effect if the pump is turned
off and then on again by disconnecting its electrical power supply.
The setting can be disabled (Off - factory default) or else can be set
to a delay time ranging from 1 to 60 minutes.
The alarm and pulse LED indicators will flash while the delay time
is in progress (1 sec ON - 1 sec Off) and the countdown will be
shown on the display in seconds. If the pump is in Stop mode, the
LEDs alone will be flashing. While the time delay is in progress, the
function can be disabled by accessing the menu and setting the
time to Off.
Press to access the modification option and use the
and buttons to set the desired value. Press
confirm and return to the main menu.
The memorised cc value per strike appears in the main
menu. It can be calibrated in two different ways:
MANUAL – manually enter the cc value per strike using the
keys and confirm by pressing the
AUTOMATIC – the pump makes 100 strikes, which are
started by pressing the
process, enter the quantity sucked up by the pump using the
keys and confirm by pressing the
The entered figure will be used in flow calculations.
The main menu displays the pump operation times. By
pressing the key you can access other statistics:
- Strokes = number of strokes made by the pump
- Q.ty (L) = quantity dosed by the pump in litres; this figure is
calculated on the basis of the memorised cc/stroke value
- Power = number of pump starts
- Reset = use the
otherwise (NO), then confirm by pressing the
Pressing the
menu.
rev 1.1
Operation
Operation
key. At the end of this
Operation
to reset the counters (YES) or
key will take you back to the main
to
key
key.
key.
6