Athena AT PR Série Mode D'emploi page 7

Paragraph 3 – Manual Dosage
Programming
PROG
Configuration
Pump Funtions
-
+
Pump Functions
Display during Operation
Operating mode

Man = Manual
Alarms and statuses

Liv = Level alarm

Fls = Flow alarm
Paragraph 4 – Setting the Maximum Flow
Programming
PROG
Pump Functions
-
Max flow rate Max flow rate
P100%
P100%
-
Max flow rate
F320s/m
Paragraph 5 – Setting the Alarm Relay
Programming
PROG
Pump Functions
-
Max flow rate
P100%
-
Alarm Relay
N.Open
-
EM00136162
The pump operates in constant mode. The flow can be manually regulated
by pressing the
or the
FLOW sensor
status
MAN F F F

Lev Stop P100%
Pump status

Empty = pump in start

Stop = pump stationary

Paus = pump in pause
-
+
-
-
+
-
-
+
-
keys to decrease it.
Current dosage value
(depends on the selected unit
of measurement)
Percentage, Frequency,
l/h, Gph, ml/m
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow. Changes can be made by pressing the
key, then using the
Press
This is used to set the alarm relay in the absence of an
alarm situation, if open (default) or closed.
Changes can be made by pressing the
using the
to confirm and return to the main menu
rev 1.1
Operation
keys at the same time to increase the flow,
Display during Setting (MODE key)
Operating mode

Displays the corresponding frequency value
F320s/m
Current dosage value

The maximum flow can be modified by
pressing the + or – keys at the same time
Operation
keys to set the new value.
to confirm and return to the main menu
Operation
keys to set the new value. Press
P100%
key, then
5