Athena AT PR Série Mode D'emploi page 4

Athena AT. PR Programming Menu
You can access the programming menu by pressing the key for over three seconds. The keys
can be used to run through the menu items, with the key being used to access changes.
The pump is programmed in constant mode in the factory. The pump automatically returns to the operating mode
after 1 minute of no activity. Any data entered in these circumstances will not be saved. The key can be
used to exit the various programming levels. Upon exiting programming, the display will show:
Exit Exit
 
to confirm the selection
No Save Save
EM00136162 rev 1.1 2