Athena AT BT Série Manuel D'installation page 9

Paragraph 7 - Statistics
Programming
PROG
-
-
Statistic
Hours 10
Statistic
Strokes 1000
-
Statistic
Q.ty(L) 100
-
Statistic
Power 10
-
Statistic
Reset
ESC
Statistic
Hours 10
-
Paragraph 8 – Password
Programming
PROG
-
-
Password
****
Password
0000
-
Paragraph 9 – Flow Alarm
Programming
PROG
-
-
Alarms Alarm Flow
Flow Off Off
Alarm Flow
On
-
Alarm Flow - On
Signals
Alarms
Flow
EM00136160
-
Statistic Reset
+
NO
-
+
-
+
-
-
+
6
ESC
Off
-
The main menu displays the pump operation times. By
pressing the key you can access other statistics:
- Strokes = number of strokes made by the pump
- Q.ty (L) = quantity dosed by the pump in litres; this figure is
calculated on the basis of the memorised cc/stroke value
- Power = number of pump starts
- Reset = use the
otherwise (NO), then confirm by pressing the
Pressing the
menu.
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the key to select the number (from 1 to 9), and the
key to select the number to be modified. Confirm by
pressing the key. By setting "0000" (default), the
password is eliminated.
This makes it possible to activate (deactivate) the flow
sensor.
When activated (On), press the
request for the number of signals that the pump waits for
before an alarm is triggered. The number flashes when you
press the key, and you can then use the
keys to set the value. Confirm by pressing the
Press to return to the main menu
rev. 1.1
Operation
to reset the counters (YES) or
key will take you back to the main
Operation
Operation
key to access the
key.
key.
8