Display during Operation
Operating mode
Timer
Alarms and statuses
Liv = level alarm
Flow = flow alarm or
....Release wait
Paragraph 3 – Timed Dosage (Frequency signal input "TRIGGER" not activated)
Programming
PROG
Configuration
Configuration
Pum functions
-
+
Pum functions
Tempo
Time
-
Quantity
100ml
Time
g.hh.mm
-
Delay
0.01.50
Time
g.hh.mm
-
Interval
0.01.50
Trigger Mode
-
Disable
Pause Input Mode
-
Restart Timer
Display during Operation
Operating mode
Timer
Alarms and Level
statuses = level alarm
Flow = flow alarm
EM00136160
FLOW
Programmed value
sensor status
Timer
F
F F
7,0 ml
Stop
P 0%
Pump status
Dry = pump starting up
Stop = pump stop
Restart = pump restart
-
+
-
+
-
+
-
+
Pause Input Mode
-
Restart Timer
Pause Input Mode
-
Freeze Time
Pause Input Mode
Pause Dosing
FLOW
sensor
status
Timer
F F
F
7.0 ml
Liv
Stop
P 0%
Pump status
Dry = pump starting up
Stop = pump stopping
Restart = pump restarting
Quantity in ml
Value of the dosing in
progress
Percentage of
strokes/min
max
The pump doses a programmed quantity in ml. It is possible to set a
pump delay time (Delay) when the pump is started and an interval
between two successive dosings (Interval), as illustrated in the
diagram:
Delay
The Delay and Interval times are in dd.hh.mm (days, hours,
minutes)
The Pause input can be programmed in three different modes:
1. FreezeTime: when the pause is activated, the system cuts
out the current time count and restarts it when the pause is
deactivated.
2. Pause Dosing: with the pause activated, the system
continues to count time the and stops the dosing.
3. Restart Timer: when the pause is activated, the system
stops the dosing and when the pause is deactivated the
count starts again from the beginning.
Durante la fase di funzionamento della pompa, è possibile
modificare
la
frequenza
contemporaneamente i tasti
frequenza oppure i tasti
Programmed value
Quantity in ml
Value of dosing in
progress:
Percentage of
strokes/min max
rev. 1.1
Display during Setting (MODE key)
Operating mode
The following are shown in sequence:
quantity to dose, delay in d.hh.mm.
and interval in d.hh.mm
Q.tà
20,0ml
20,0ml
P 100%
Value of the dosing percentage,
which can be modified by
pressing the + or – keys
Operation
Quantity
Interv.
di
dosaggio
per diminuirla.
Display at start-up (MODE key)
Modalità di funzionamento
Vengono visualizzati in
sequenza:quantità da
dosare, ritardo in g.hh.mm e
intervallo in g.hh.mm
Q.tà
20,0ml
20,0ml
P 100%
Valore della percentuale di
dosaggio, modificabile premendo
sui tasti + o -
Dosing value
Programmed
quantity in m
l
premendo
per aumentare la
Valore del dosaggio
Quantità
programmata in
ml
6