Paragraph - Athena AT BT Série Manuel D'installation

Paragraph 10 – Level Alarm
Programming
PROG
-
-
Alarms
Level Stop
-
Paragraph 11 – Flow Display Unit
Programming
PROG
-
-
Unit
Standard
-
Paragraph 12 – Setting the Pause
Programming
PROG
Configurazione
+
Paus
N.Aperto
-
Display contrast adjustment.
For adjusting the display contrast keep the key
to increase or decrease the contrast.
Alarms
Display
Fixed alarm LED
Flashing word "Lev"
I.e. Man
Lev
Fixed alarm LED
Flashing words "Lev" and "stop"
I.e. Man
Lev Stop
Fixed alarm LED
Flashing word "Flw"
I.e. Man F
Flw
I.e.
Parameter Error
PROG to default
EM00136160
Alarm Level
Stop
-
Alarm Flow
Alarm
ESC
Alarms
Level Alarm
-
Unit
Standard <-
-
+
Unit
L/h
-
-
+
-
End of
interrupting pump operation
P100%
End of level alarm, with interruption
to pump operation
P100%
Active flow alarm. The pump has
not received
number of signals from the flow
sensor.
P100%
Internal CPU communication error.
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
using the
pressing the
main menu
measurement on the display.
Changes can be made by pressing the
using the
choosing between L/h (litres/hour), Gph (Gallons/hour), ml/m
(millilitres/minute) or standard (% or frequency, depending
on settings). Press
main menu
The pump can be paused by remote input.
The factory setting is Normally Open.
Changes can be made by pressing the
using the
N. CLOSED).
Press to confirm and return to the main menu.
pressed and within 5 seconds press the keys
Cause
level alarm, without
the programmed
rev. 1.1
Operation
keys to set the alarm type. Confirm by
key. Press
Operation
keys to set the unit of measurement,
to confirm and return to the
Operation
keys to set the new value ( N. OPEN or
Interruption
Restore the liquid level.
Restore the liquid level.
Press the
Press the
the default parameters.
key, then
to return to the
key, then
key, then
or
key
key to restore
9