emerio FN-110139.1 Mode D'emploi page 5

FN-110139.1
PARTS DESCRIPTION
1. Front guard
2. Blade
3. Fixation screws for rear guard
4. Rear guard
5. Handle
6. Grill locking screw
7. Blade fastening screw
8. Motor shaft
9. Motor unit
10. Oscillation knob
11. Speed control switch
12. Connecting screw and nut
13. Standing shaft
14. Standing base
15. Ring
16. Fastener
17. Base locking screw
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
1. The stand assembly
Take off the ring (15), fastener (16) and base locking screw (17) from the standing shaft (13).

Insert the standing shaft into the center hole of standing base (14). Place the ring, fasterner and base locking

screw in sequence to the bottom of standing base. Fix the connection of standing shaft by tightening the
fastener and base locking screw.
2. Fan head assembly
Place the Motor unit (9) on the top of standing shaft. Use the connecting screw and nut (12) to tighten the

connection, fixing the fan head onto the pipe.
3. Rear guard assembly
Fit the rear guard (4) onto motor with the handle on the top. Tighten the rear guard with 4 fixation

screws (3).
4. Fan blade assembly
Install fan blade (2) onto motor shaft (6) and use the blade fastening screw (7) to fix the blade.

5. Front guard assembly
Put the hook of the front guard (1) onto the top of rear guard.

Attach front guard to rear guard, close clips and use the grill locking screw (6) to secure the two grilles

together.
- 4 -
EN