Brother NC-2200w Guide D'installation Rapide page 7

Setting up the Print/Scan
Server
Step 1
Installing the Print Server
The NC-2200w cannot be used with a
USB HUB.
1
Connect the USB cable to the NC-2200w
and Brother Printer/MFC/DCP.
2
Connect the AC adapter to the
NC-2200w.
3
Plug in the AC Adapter and turn on the
Brother Printer/MFC/DCP.
4
Make sure that the Link LED of the
NC-2200w is on and wait for a few
minutes.
Link LED (Green)
Before installation, if you are using
Personal Firewall software (e.g. the
Internet Connection Firewall available in
Windows XP), disable it. Once you are
sure that you can print, re-start your
Personal Firewall software.
Step 2
Changing your Computer's
Wireless Settings to configure
the NC-2200w
Before you can use the Brother
Printer/MFC/DCP in a wireless network, the
NC-2200w must be configured to match your
network configuration.
To configure the NC-2200w from a wireless
computer on your network, you must
temporarily change your current wireless
settings. Before changing the current
wireless settings of your computer, we
recommend you make a note of your current
wireless network settings. You will need to
return to these settings at the end of Step 3
on page 9.
We recommend you to contact your
network administrator if you need
assistance with your computers
wireless settings.
Current wireless network settings of
your computer
Item
Communication Mode:
(Infrastructure / Ad-hoc)
Network Name
(SSID/ESSID)
Channel: (1-14)
*If necessary.
Encryption:
(NONE / WEP / Other)
Encryption Key Size
and Type:
(64 bit, 128 bit / ASCII,
HEX / Other)
Encryption Key:
English
Current Setting
6