Brother NC-2200w Guide D'installation Rapide page 15

■
Some MFC/DCPs with the NC-2200w cannot
be found in the search list during installation. In
that case go back to the screen shown below
and set the node name of the NC-2200w
manually. You can see the node name on the
Network Configuration page, see Other
Information on page 16.
Step 5
Specifying the Scan Destination
Address from the NC-2200w Home
page
You need to specify the scan destination
address from the NC-2200w URL to use the
scanner on a network. Follow the steps
below.
1
Open the Internet Explorer and enter the
following in the URL field.
http://NC-2200w_ip_address
Where NC-2200w_ip_address is the
IP address or node name of your
NC-2200w.
■
The IP address or node name of your
NC-2200w is on the Network
Configuration Page. For more
information, see Other Information on
page 16.
■
You will be asked for a user name and
password. Enter the following.
users name : admin (case sensitive)
password: access (default)
2
Go to the General page under
Configuration.
(Available languages are English, German,
French, Dutch and Japanese.)
3
Enter the IP address of your computer.
■
If the IP address of your computer was
assigned automatically by DHCP, you
should enter the computer name
because the IP address may change.
The name can be the Windows
computer name or the DNS host name.
■
To learn your computer name, open
Properties from My Computer and
refer to the Computer Name tab. To
use the domain name you have to
assign the DNS server address using
the Web server of the NC-2200w and
your Web Browser.
Setup is now complete.
English
®
14