Setting Up; Switching Your Unit On And Off; Initial Configuration - HEINE EN200 BP Mode D'emploi

5. Hang the device – disconnected from the mains – on the two screw heads,
press firmly and push downwards. Check to make sure that the device is
correctly positioned on both screw heads.
6. Additionally, the lower screw can be fixed, in order to avoid the device from
slipping off the mount. If you do fix the lower screw, please stick the enclosed
identification plate visibly on the bottom of the housing.
For disassembly, remove the plug-in transformer from the mains socket, loosen
the lower screw, push upwards and take it off the wall.

1.3.2 SETTING UP

One option is to connect the USB cable to the HEINE plug-in power supply, attach
the primary adapter to the plug-in power supply until it latches into place, and then
connect the primary adapter to the socket. The other option is to use the HEINE
EN200 wall transformer for power supply.
Primary plug
The device may only be operated with the supplied power supply unit.
Use only original HEINE accessories.

1.3.3 SWITCHING YOUR UNIT ON AND OFF

To switch the device on, hold down the
switch itself off after around 2 minutes if no other buttons have been pressed in that
time. On the start screen, it is also possible to switch off the unit by pressing and
holding the -button for around 1 second.

1.3.4 INITIAL CONFIGURATION

Switch on the unit. You will be taken directly to the initial configuration menu when
first switching on your device. This is where you can perform the following settings:
LANGUAGE
Set the language with the navigation buttons
entry with the confirmation button
This will also define the date and time format.
DATE
Set the current date using the navigation buttons
Confirm the entry using the button
TIME
Set the current time using the navigation buttons
Confirm the information entered using the confirm button
EU USA / Japan
MED 113275
UK Australia
-button for about 1 seconds. The unit will
.
.
2018-02-26
®
and confirm the
.
.
.
45/212