Jotul F 164 Manuel D'installation Et D'utilisation page 12

ENGLISH
Fig. 8
7. Unscrew the screws (Fig. 8 C) and remove the cover (Fig. 8 B)
from the rear outlet from the inside of the burn chamber.
Fig. 9
8. Knock out the removable cover plates (Fig. 9 A).
9. Attach the smoke outlet (Fig. 8 A) on the inside of the burn
chamber where the cover was.
10. Install the cover (Fig. 8 B) where the smoke outlet was.
11. Refit the exhaust deflectors (Fig. 6 B) and the baffle plate
(Fig. 6 A).
12
4.8 Control of functions
When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Jøtul F 164, F 165, F 166 and F 167 are equipped with the following
control:
Ignition vent/air vent
Ignition
Fig. 10
• Open the ignition vent and air vent by pulling the handle all
the way out. (Use a glove or something similar to protect your
hand in case the handles are hot.)
• Place two logs at the bottom of the burn chamber and pile
the kindling in layers.
• Finally, place a medium-sized log on the top of the pile.
• Place 2 or 3 briquettes or kindling sticks under the top layer
of kindling and light the fire.