Getting Started - Remington Endurance Groomer MB4200 Mode D'emploi

Masquer les pouces Voir aussi pour Endurance Groomer MB4200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
ENGLISH

GETTING STARTED

CHARGING YOUR APPLIANCE
Only charge from 5V DC 0.5-1.0A (minimum) adapters.
Note: It is recommended to fully charge your appliance before using for the first time.
Please refer to the charge times shown in this book.
Ensure the product is switched off.
Connect the product to the USB cable and then the USB end of the cable to a powered
USB port.
CHARGE LEVEL INDICATORS
Charge Level
Charging
Low battery
Fully charged
When in use;
3 Blue LEDs indicate 70% - 100% charge remaining.
2 Blue LEDs indicate 40% - 70% charge remaining.
1 Blue LED indicates 10% - 40% charge remaining.
1 Red LED indicates 5% - 10% charge remaining. 1 Red flashing LED indicates less than
5% charge remaining as noted in the above section on low battery charge level
indicator.
Run time from fully charged is up to 90 minutes when not operated in turbo mode.
Charge time from empty is 4 hours.
QUICK CHARGE FUNCTION
The trimmer has a 5 minute quick charge feature that will provide enough charge for 1
grooming session.
ENDURANCE TECHNOLOGY AND TRAVEL LOCK
The product will only charge when the travel lock, found on the back of the product is
disabled.
To enable the endurance technology to operate please ensure you activate the travel
lock in between uses of the groomer by sliding down the travel lock.
INSTRUCTIONS FOR USE
Switch the product on by pressing the On/Off switch.
This model has a turbo mode that can be activated by pressing down the On/Off switch
for 2 seconds.
4
Indicator
LED flashes
LED flashes red
LEDs show solid

Publicité

Table des Matières
loading

Table des Matières