Service; Accessories - Dustcontrol DC 5800c 9.2 kW P Manuel D'instruction

Service

With cleaning and maintenance on the machine,
the power cable should be disconnected from the
supply.
The fi ne fi lter should be changed at least once per
year. Use only original spare parts. If the machine
is used with a microfi lter/HEPA fi lter, this should
be changed every 300 running hours. Use breathing
protection when changing the fi lter. Used fi lters
should be sealed in a plastic sack and disposed of
properly.
Check regularly that the electrical cable is not da-
maged.
The DC 5800c 9.2 kW P should be performance
tested at least once per year because it may be used
with hazardous materials. Worn parts must be re-
placed.
Never compromise the function of the
DC 5800c 9.2 kW P, use only original spare parts.
The pump should be inspected and lubricated at least
once a year.
1. Start the pump and listen for abnormal sound.
2. Shut off the pump and lock out the electrical

Accessories

Description
Plastic sacks, standard
Fine fi lter
Microfi lter
Warranty
The warranty period for this machine is two years
and covers manufacturers faults. The warranty is
valid under the condition that the machine is used
under normal conditions on the task for which it was
designed and is maintained properly.
Part no
4614
4292
4017
DC 5800c 9,2 kW P - 10
ser-vice.
3. The turbopumps bearings should be lubricated
with lithium based bearing grease, art nr 9683.
- The back bearing should be lubricated by remo-
ving the fi nned bearing cover plate.
- Check the condition of the grease. Fill the cavi
ty 2/3 full with new grease.
- Exchange the O-ring, art nr 4789 and replace
the bearing cover plate.
4. Inspect all cables and connections, repair if
neccessary.
Other accessories — see Dustcontrol
catalogue.
Normal wear is not covered by this warranty. Service
performed by other than Dustcontrol or its autho-ri-
zed agent voids automatically the warranty. No other
warranty express or implied is applicable.
Part No 9092