Connections; Connecting The Network; Connecting Audio; Connecting Alarms - Eneo IED-63F0037M0A Guide D'installation Rapide

Connections

Connecting the Network

Connect a standard RJ-45 cable to the network port of the camera. Generally a crossover
cable is used for directly connection to PC, while a direct cable is used for connection to a
hub. You can also use a router featuring PoE (Power over Ethernet) to supply power to the
camera.

Connecting Audio

Connect speaker to audio output line and external mic to audio input line.

Connecting Alarms

AI (Alarm In)
You can use external devices to signal the dome camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G (Ground)
Connect the ground side of the alarm input and/or alarm output to the G (Ground)
connector.
AO (Alarm Out)
The dome camera can activate external devices such as buzzers or lights. Connect the
device to the AO (Alarm Out) and G (Ground) connectors.

Connecting the Power

Connect power of 12VDC 450 mA for the network camera.
Connect the positive (+) pole to the '+' position and the negative (-) pole to the '-' position.
EN
9