Eneo IED-63F0037M0A Guide D'installation Rapide page 12

Reset Button
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the top cap.
3. Press and hold the Reset button with a straightened paperclip while reconnecting
the power.
4. Keep the Reset button pressed until the Status indicator blinks.
5. Release the Reset button.
6. When the Power Indicator changes to Green (may take up to 40 seconds), the
process is complete and the network camera has been reset.
7. The network camera resets to factory default and restarts after completing the
factory reset.
8. Close the bottom cap tightly to ensure waterproofness.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.1.10)
12
microSD Card Slot