Intended Use; Improper Use; Residual Risks; General Safety Notices - Cartrend 146000 Notice D'instructions Originale

Warning!
Several safety measures must be observed when
using equipment in order to avoid injury or damage.
Consequently, please carefully read this instruction
manual / these safety notices. Keep them in a safe
place to enable you to access the information at all
times. Should you pass on the device to another
person, please hand over this
instruction manual / these safety notices
along with it. We will not accept any liability for any
accidents or damage caused by non-observation of
these instructions or the safety notices.

INTENDED USE

This tool is suitable for loosening or tightening nuts
and bolts.Using the tool for other kinds of work is
dangerous and absolutely must be avoided. While
the tool is in use the tool user must ensure that
adequate protective equipment is worn/is in place
in accordance with the instruction manual and the
warning pictographs on the machine. Prior to every
use and during use of the device, the device and the
screwdriver bit must be checked for any functional
or mechanical damage. Should any damage to the
tool be identified, cease all work with it immediately
and contact a specialist workshop.

IMPROPER USE

Any application of the device other than those
stated in the chapter "Intended use" will be deemed
improper use. The device may not be used for the
following purposes:
- Any use that is not listed as an intended use
- Use as a mounted device
- Use as a drive for other devices
There is a risk of injury. The user of the device will be
liable for all damage to property and personal injury
resulting from misuse.
Use of other or non-OEM components on the
machine will void the manufacturer's warranty.

RESIDUAL RISKS

Even when using the tool correctly there is always a
certain amount of residual risk that cannot be exclu-
ded. The following potential hazards can be derived
from the nature and design of the tool:
- Contact to the unprotected screwdriver bit (cutting
injury)
- Hearing damage if the prescribed hearing protec-
tion is not worn (loss of hearing) If the instructions
contained in the instructions for use are not obser-
ved, other residual risks may arise on account of
incorrect usage.

GENERAL SAFETY NOTICES

WARNING Read all safety notices and
instructions. Any failure to comply with
safety
notices and instructions may cause electric shock,
fire and/or severe injuries.Please keep all safety
notices and instructions for future reference.
The term "electric power tool" use in the safety
notices refers to all mains power electric power tools
(with power cable).
1) Workplace safety
a) Keep your working area clean and
well illuminated. Untidiness and/or unilluminated
working areas may cause accidents.
b) Do not work with the electric power tool in an
explosive environment where there are com-
bustible liquids, gases or dusts. Electric power
tools give off sparks that may ignite the dust or the
vapours.
c) Keep children and other persons away when
using the electric power tool. If you are distracted,
you may lose control of the device.
18