Installation - Klarstein COLDPLAYER Mode D'emploi

INSTALLATION

1 Open the packaging and remove the device. Check that the remote control and the
two ice boxes are inside the box.
2 Place the unit in a horizontal position and do not tilt it during use. Before use, check
the voltage on the device label. Only connect the unit to sockets that correspond to
the voltage of the unit.
3 Open the side cover of the appliance and pour water into the funnel. Pour the water
slowly into the water tank. When the tank is full, close the side cover again.
Note: When adding water, pay attention to the water level of the appliance, do not
exceed the MAX mark and do not fall below the MIN mark on the water level scale.
Add water to the MAX mark before use.
Fill with water here
Max water level
Min water level
EN
19