Bosch PL1632 Consignes De Fonctionnement/Sécurité page 12

2610035776 01-15.qxp_PL1632 1/14/15 9:34 AM Page 12
UNCLOGGING THE SHAVINGS
EXHAUST SYSTEM
Remove plug from power
source
necessary to manually remove shavings. WARNING
The blades are hidden from view and you may
be cut if contacted.
To minimize the possibility of clogging, make sure:
RABBETING
Although all of the compatible Bosch planer
guide fences can be used with the PL1632 for
rabbeting (sometimes called "shiplapping"), the
best fence for this purpose is the optional dual-
mount fence.
The PL1632 can create rabbets up to 82 mm /
3-1/2" wide. (Fig. 10). Keep in mind that it
takes steady sideways pressure and many
passes to create rabbets using a planer.
RABBETING DEPTH STOP
The optional rabbeting depth stop (Fig. 10)
allows the user to set any rabbeting depth from
0 to 5/16" (9 mm). For best results, it is
important that the blade be properly aligned
(See "BLADE ALIGNMENT").
Setting the rabbet depth: Loosen wing knob
Preventive maintenance
performed by unauthorized
WARNING
per so n nel may result in misplacing of
internal wires and components which
could cause
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho -
rized Bosch Service Station.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready to use. It is recommended that
tools with gears be regreased with a special
gear lubricant at every brush change.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Bosch replace ment brushes
specially designed for your tool should be
used.
if it becomes
Maintenance
Service
serious hazard.
1. The depth of cut is reasonable for the
material.
2. The feed rate is reasonable for the material.
(See DEPTH OF CUT AND FEED RATE)
3. Unplug the planer and carefully insert a
screwdriver or similar object into the
exhaust port to break up the clog.
FIG. 10
RABBETING
DEPTH STOP
9mm
max.
and using the depth scale on the rabbeting
depth stop, set the desired rabbet depth.
Securely tighten wing knob (Fig. 10).
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
We
WARNING
the power supply before cleaning or
performing any main tenance. The tool may
be cleaned most effectively with compressed
dry air. Always wear safety gog gles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
CAUTION
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold detergents
that contain ammonia.
Clean the planer stand regularly and ensure
that it springs back freely.
-12-
WING
KNOB
BEARINGS
Cleaning
To avoid accidents always
dis connect the tool from
Certain cleaning agents
and sol vents damage