Parameter Level; Settings - Ecolab LMI 02 Notice Technique

7.3

Parameter level

7.3.1

Settings

The following settings can be performed in the parameter level
(PARAMETER FUNCTIONS):
•
ADJUSTMENT FUNCTIONS
- Adjust the conductivity display (CONDUCTIVITY +/- 0.0 % = XXX mS/cm)
- Adjust the temperature display (TEMPERATURE XX °C)
•
DEFINE METERING SETTINGS (factory setting in brackets)
- Set pre-metering time
- Set pre-metering delay
- Set concentration of SP1
- Set concentration of SP1
- Set temperature compensation for alkali or acid detergent
(TEMPERATURE COMP. ALKAL ACID)
•
ALARM CONTROL SETUP
- Set delay time for detergent
empty message (EMPTY DETERGENT DELAY: 0005 s)
- Set maximum metering time
- Set manual metering time
- Set concentration overdose of detergent (DET. OVERDOSAGE CONZ.: 100 mS/cm)
- Set delay time for detergent concentration overdose message
(DET: OVERDOSE DELAY: 120 s)
- Set lower limit for temperature (TEMPERATURE MINIMUM: OFF)
- Set delay time for temperature lower limit alarm (only shown if temperature value set)
(TEMPERATURE DELAY: 0120 s)
- Set repeat alarm (ALARM REPEAT TIME: OFF)
•
SET PARAMETERS TO DEFAULT
- Resets parameters to the factory settings (ARE YOU SURE?)
The programming steps and display texts described in the following sections of this
NOTE
chapter are summarised in the "Programming Structure" overview in the Appendix.
417102012_LMI02.doc
(PREMETERING TIME: 0120 s)
(PREMETERING DELAY: 000 s)
(CONZENTRATION SP1: OFF mS/cm)
(CONZENTRATION SP2: OFF mS/cm)
(DETERGENT DELAY TIME: 0180 s)
(MANUAL DOSING TIME: 0120 s)
- 74 - Rev. 10-01.09