LBC LRO-1G5 Manuel De L'opérateur page 33

To set Vent Functions
The vent button (F) selects the way the vent will operate during the bake. There are
three options: 1) "OPEN" will cause the vent to be open all times while the oven is
baking except during the time that the steam timer is counting down. 2) "AUTO" will
cause the vent to open during the last third of the bake cytle. 3) "CLOSED" will cause
the vent to stay closed through the entire bake cycle. Note that this function will be
locked out if the control is configured with the programming limitation feature turned
on.
To start the Bake Timer
Press the "START/STOP" button (G) to start the bake after loading the oven with the rack of
product. The loading door must be closed for the bake timer to start. Once the start button is
pressed, the steam time will count down if the steam time is set. If the loading door is opened,
the bake timer and steam timer will pause. The timers will resume automatically when the door
is closed.
End of Bake Alarm
When the time has run out, the time display will show two dash lines. The timer alarm will
sound. You may add time to the bake by pressing the up button (C) in the timer display. The
timer will automatically resume. You may also press the "START/STOP" button (G) to silence the
alarm and then adjust the time. If you press the "START/STOP" button (G) again, the displays
will reset to the original bake time and steam time. You may also open the door to silence the
alarm and check the baking progress.
Selecting Preset Recipes
To select a preset recipe, press the left and right buttons next to the "SELECT PRESET" display (I).
The preset that is shown will be the recipe that will be operating when the "START/STOP"
button (G) is pressed. Note: if the control is configured for Step Recipe operation, the six
buttons above the "SELECT PRESET" will indicate the step that is being executed (see Step
Recipe Operation for specific instructions).
Saving a Preset Recipe
A recipe may be saved as a preset recipe in the following manner. 1) Select the preset number
(H) under which you want to save the recipe. 2) Enter all of the settings. 3) press the "SAVE"
button (J) twice. Note that this function will be locked out if the control is configured with the
Programming Limitation (PL) function turned on. In order to save a recipe, the programming
limitations feature must be turned off to save and can then be turned on to prevent any
changing the recipe.
Copyright 2016-2018 LBC Bakery Equipment Inc. Marysville WA USA
P a g e | 33